The main part of the project was adding the casting deck. It is made from 5/8" exterior plywood, and uses aluminum angle pieces for support.
This shows the main hatch which hides the main fuel tank. Aluminum angle and bench seat support the hatch door.
This shows two of the three utility/cup holders. Power plug and fire extinguisher fill out the console. Also notice fuel primer bulb below engine controls.
New Guest dual battery on-board charger and LED utility light.
New rear pedistal seat in the raised position. Low position for when boat is under way.
Head on shot.
From the rear.
In progress or how to make a mess out of the garage.
